Rooftop solar panel cleaning in California

The panels on your roof catch everything the coast sends their way: salt mist, street dust, dew spots and the odd gull. We wash them the slow, gentle way, with purified water and soft brushes, early in the day while the glass is cool.

Request this cleaning(975) 207-8521

Soft brush on a water-fed pole moving across a dusty rooftop solar panel, with a red tile roof and a palm behind

Why rooftop panels get dull so quickly here

Near the ocean, the morning marine layer leaves a fine damp mist on every surface. On a tilted panel that mist carries salt, and as the sun burns the haze off, the water dries and the salt stays behind. Week after week it builds into a cloudy film. A few miles inland the salt gives way to dust, and the effect is much the same: glass that looked dark and clear when the panels went up turns gray and flat.

Rain helps less than people expect. A short winter shower moves loose dust around, then dries into fresh spots along the bottom edge of each panel. Clean glass simply lets more sunlight reach the cells, and a gentle wash every few months keeps the surface the way it was meant to look.

How we wash a rooftop array

We start in the cool morning hours, before the glass heats up, because cold water on hot glass is never a good idea. A water-fed pole lets us reach most rows from a safe footing, and the water running through it is purified first, so it dries clear without leaving new mineral spots.

A soft, non-abrasive brush loosens the film, then a slow rinse carries it down and off the panel. No harsh chemicals, no scraping, and never a pressure washer on the glass. Stubborn spots, such as dried droppings, get a little more water and patience rather than more force.

Clay tile, shingle and flat roofs

Red clay tile is common across the South Bay, and it deserves care: tiles can crack under a careless step. We plan our path along the strongest points, use a ladder stabilizer so the ladder never rests on the gutter, and wear a harness whenever we work on the roof itself. On composition shingle and low-slope roofs the approach is the same, just with different footing.

If we notice something unusual while we work, such as a cracked panel, a loose piece of trim or leaves packed under the array, we tell you and send a photo. We stick to cleaning and leave anything else to the right specialist.

Before we arrive

  • Let us know the roof type and how many stories the house has
  • Leave the side gate open and keep pets inside for the morning
  • Move cars away from the side of the house where we set the ladder
  • Tell us about any sprinkler timers near the work area

Questions about rooftop panels

How often should rooftop panels be cleaned near the coast?

Most homes within a mile or so of the water do well with a visit every three to four months. Farther inland, twice a year is common. We can look at your panels and suggest a rhythm that fits your street.

Do I need to be home?

Not always. If we can reach the side yard and the water spigot, many customers leave the gate open and get the photos by text or email afterward.

Will the water hurt the roof or the panels?

We use a modest amount of purified water at normal hose pressure. It runs off the glass the same way rain does. We never use a pressure washer on panels.

Can you clean a two-story roof?

Yes, in most cases. Tell us in the form and we will plan the pole length, ladder position and harness setup before the visit.

Ready for clear glass again?

Tell us the roof type, how many stories and roughly where you are. We reply during office hours with the first open morning.